DSX-CHA004 Cable Adapter Fluke Networks

DSX-CHA004電纜RJ45通道認證模塊，（鄒先生1-3 7- 1 5- 29 - 75 1 0）DSX-CHA004通道與鏈路的區別，DSX-CHA004 Cable Adapter Fluke Networks！

自檢：使用DSX-5000 CableAnalyzer驗證DSX-PLA004和DSX-CHA004適配器

如果在測試時收到故障，則可能是DSX-PLA004鏈路適配器出現故障。如果您也在執行通道測試，那么您也可能有一個有故障的DSX-CHA004通道適配器。

6類自檢將有助于確定您是否有故障DSX-PLA004鏈路或DSX-CHA004通道適配器。

將DSX-5000 CableAnalyzer模塊插入主機架。

接通主設備和遠程設備的電源。

將DSX-PLA004鏈路適配器插入版本V/TFS主機上的DSX模塊。（帶液晶顯示器的那個）

將一個DSX-CHA004通道適配器插入另一個DSX模塊，并將適配器直接連接在一起，如下所示：

Press the HOME button

Tap on the Test Limit field, which is the large rectangular area just below the PROJECT section.

Tap on NEW TEST in the lower left corner.

In the TEST SETUP screen, tap on the Test Limit: bar.

Tap on MORE in the lower right corner.

Select Application.

Swipe up to select Cat6 Selftest.

Tap on the Cable Type: bar.

Select Cat 6 F/UTP. (If you do not see this, tap MORE > Generic)

IMPORTANT: In the TEST SETUP screen, tap SAVE in the lower right corner:

按HOME按鈕

輕觸TestLimit字段，它是項目部分正下方的大矩形區域。

點擊左下角的NEW TEST（新測試）。

在測試設置屏幕中，點擊測試限制：欄。

點擊右下角的“更多”。

選擇應用程序。

向上滑動可選擇Cat6自檢。

輕敲電纜類型：巴。

選擇6類F/UTP。（如果看不到，請點擊“更多>常規”。）

重要提示：在“測試設置”屏幕中，單擊右下角的“保存”：

Self test: DSX-PLA004 and DSX-CHA004 adapter verification with the DSX-5000 CableAnalyzer

If you receive failures when testing, there is the possibility of a faulty DSX-PLA004 Permanent Link Adapter. You could also have a faulty DSX-CHA004 Channel Adapter if you were carrying out Channel testing too.

A Cat 6 Self Test will help to determine if you have faulty DSX-PLA004 Permanent Link or DSX-CHA004 Channel Adapters.

Insert the DSX-5000 CableAnalyzer modules into the main frames.

Power up the main and remote units.

Plug in a DSX-PLA004 Permanent Link Adapter into the DSX module on the Versiv/TFS main unit. (The one with the LCD)

Plug in a DSX-CHA004 Channel Adapters into the other DSX module, and connect the adapters directly together as shown below: